WakeWorld

WakeWorld (http://www.wakeworld.com/forum/index.php)
-   Boats, Accessories & Tow Vehicles (http://www.wakeworld.com/forum/forumdisplay.php?f=3183)
-   -   1992 MC Prostar 205 Oil and Fuel Gauge (http://www.wakeworld.com/forum/showthread.php?t=799980)

ncsupra 09-16-2013 8:43 AM

1992 MC Prostar 205 Oil and Fuel Gauge
 
I just purchased a 1992 MC Prostar 205. The oil and fuel gauges do not work. The volt meter and engine temp gauge work fine. The previous owner said the sending units were bad. I replaced the oil sending unit, but the gauge still registers 0 psi. The oil level is fine. I have not tested the oil pump yet. I hear a faint audible squeal when the engine is running. Itís coming from a circuit board behind the dash.

Is the noise a low oil warning or something else?

What are the other causes for the gauge to read 0 psi?

How would I check to see if the gauges are bad?

Is there a common ground that the oil and fuel gauges use and maybe corroded?

Thanks for helping.
SWH

phatboypimp 09-16-2013 5:36 PM

that era of Mastercraft boats had all kinds of gauge problems. I ended up getting my 1996 prostar gauges replaced as well as my 2001 gauges under warranty. I am not sure what the issue is but if you head over to the mastercraft forum you will likely find all the information you need.


All times are GMT -7. The time now is 4:26 AM.