2009 Company Bindings
 

I was curious what the hole spacing was for the 2009 Company Bindings. I bought a prototype board from a company that was trying the 4 hole pattern and rather than drilling in new inserts, I have heard good things about the Company Bindings and thought that if they would fit I may try them instead. Also I wear a 10.5 shoe, does anyone know what size Company binding I would wear. Thanks.

Patrick,

You should be able to use the 4 hole with the company bindings. They come with both the 4 hole plates as well as 6" plates. If you wear a 10.5 shoe I would go with the 11 binding. They run a touch small.

Bizz, my only concern is that this 4 hole pattern was never put into production, and the board doesnt have any two hole inserts, so before I buy them I just need to know the spacing on the bindings from center-center to make sure they will fit. Thanks for the help on the size, do you know if they run narrow, wide or pretty standard as far as width goes? I have pretty narrow foot. Thanks again.

Thought I would bump this up for Monday morning. Is there anyone out there that can help me out?

They measure 1.5" square.

Awesome, Thanks for the help Bizz.

Not a big fan of the 09 Company Boots...