WakeWorld

WakeWorld (http://www.wakeworld.com/forum/index.php)
-   Archive through March 24, 2008 (http://www.wakeworld.com/forum/forumdisplay.php?f=562537)
-   -   What size hole to drill for thru hull ballast bilg (http://www.wakeworld.com/forum/showthread.php?t=560052)

sscott0203 03-20-2008 9:37 PM

Drilling 3 more holes in my boat tomarrow for my upgraded ballast on my 05 mobius lsv. I just have the standard black thru hull fittings. Anyone tell me what size hole saw i need to buy

chpthril 03-21-2008 5:39 AM

Best advise is to measure the OD of what you plan to stick through the hole!

rich_g 03-21-2008 8:48 AM

when you mark your location below the rubrail, make sure to account for the flange on the thru-hull fitting. IOW, you could drill a hole the right size for the part that goes thru, but not far enough below the rubrail for the bigger diameter of the outside part.

chadgreg 03-21-2008 10:26 AM

I bought a 1 1/16" hole saw for the thru hulls that I have. Don't forget to cut a test hole in a scrap piece of wood first.

lovin_the_wake 03-21-2008 11:41 AM

for the standard bilge thru-hulls they should be 3/4" that's what I used


All times are GMT -7. The time now is 12:33 AM.