WakeWorld

WakeWorld (http://www.wakeworld.com/forum/index.php)
-   Archive through August 06, 2007 (http://www.wakeworld.com/forum/forumdisplay.php?f=487398)
-   -   replace a ppi 4125? (http://www.wakeworld.com/forum/showthread.php?t=484325)

dizzyj 08-02-2007 2:27 PM

on of the channels on my 4125 is acting flaky. I have to hold the plugs down to get the channel to work. <BR> <BR>So, instead of one 4125, I could use a zapco, or run with 2 amps. any suggestions? im running a pair of tyrans, and I insist on running enough, if not more than enough power to em.

sbilyeu 08-02-2007 4:06 PM

Try a MCA5004 by Memphis. It has the same rating as the PPI, fan cooled. Good amp.

wikd281 08-02-2007 4:11 PM

I had the same problem with one of my PPI amps. You can either send it back to DEI and they will repair it for you or if its something like what happened to my amp. The solder weld for for wires that are on the RCA's came loose. I opened up the amp and then re-soldered the wires back on. I hear its about $125-$250 for DEI to repair it. If you dont want the amp anymore and want to use it as a boat anchor......I'll take it! <BR>Hope that helps!

murphy8166 08-02-2007 4:30 PM

I got one for sale that works perfectly. Anyone intrested.

dizzyj 08-02-2007 4:31 PM

Harold, <BR> <BR>that sounds exactly like whats happening. I think ill open er up and hit er with the soldering iron. worth a shot before I spend the money on a new amp.

wikd281 08-02-2007 5:03 PM

yeah, for me it was where the wires are soldered onto the RCA connections. One side of my tower speakers would turn on/off. As soon as I would move the RCA connections just a little, it would pass the current and would work again. Give it a shot!

alanp 08-02-2007 5:06 PM

damn thats a tuff amp replace. hopefully you get it fixed. <BR> <BR>murphy what are you asking for your amp? why in the world would you wanna sell it. those just simply pound

murphy_smith 08-02-2007 5:50 PM

I have two of these amps so I want to sell one of them. I'd let it go for $340 shipped.

cyclonecj 08-03-2007 8:45 AM

You can fix it yourself if you are not a complete idiot with a soldering iron. Open it up, look at the back side of the board and then wiggle the RCA connector. You will see the cracked solder joint move a bit. Just reflow the solder, fixed.


All times are GMT -7. The time now is 7:37 PM.