WakeWorld

WakeWorld (http://www.wakeworld.com/forum/index.php)
-   Archive through June 17, 2007 (http://www.wakeworld.com/forum/forumdisplay.php?f=464977)
-   -   Velvet Drive Transmission question (http://www.wakeworld.com/forum/showthread.php?t=463084)

kalenk 06-14-2007 5:40 PM

How do you do a trans flush on a velvet drive. <BR>thanks!

mikeski 06-14-2007 6:03 PM

Pump it out.

kalenk 06-14-2007 8:50 PM

could you be a little more specific, please. <BR><img src="http://www.wakeworld.com/MB/Discus/clipart/biggrin.gif" border=0>

mikeski 06-14-2007 8:56 PM

1. Remove the dipstick <BR>2. Place tube from suction pump all the way to the bottom of the case <BR>3. Pump until all fluid is removed <BR>4. Replace fluid with new ATF up to full mark on dipstick. <BR> <BR>If there was water in the fluid it make one or two more changes before all the foam is gone.

trace 06-15-2007 6:14 AM

The dipstick isn't always accurate on the trailer - the boat needs to be in the water. I suppose you could check the level on the water to make sure it's right, and then scratch your own "full on trailer" line on the dipstick if it's different. You can also just measure the amount you pumped out and replace that much.

plhorn 06-15-2007 12:21 PM

When I got water in my transmission (friend swamped the boat-long story) the dipstick method didn't do a good enough flush. So if your just changing the fluid for fresher fluid use the dipstick, if its been contaminated: I finally had to pull off the cooling unit and drain the fluid from there, also be sure to blow the fluid out of the cooling can at the same time.

kalenk 06-15-2007 9:00 PM

thank you very much


All times are GMT -7. The time now is 6:47 PM.