Gauges for Fat Sacs
Has anyone on here tried or thought about a way to make a gauge for fat sacs to so you could see how full they were without looking? I realize it's not that big of a deal to just open the hatches and look, but it would be cool to not have to. I have some ideas but I'm not sure if it would actually work or be cost effective.
|
Timer module with an output to a gauge. Tige does it on their 2010's, but it's not shown on a gauge, but the LCD screen.
|
I don't know what type of senders they use, but you can buy the nautique gauges
http://nautiqueparts.com/gauges_ballast.aspx |
It would seem that you would have to use some sort of flow meter on the input to each bag to gauge how much water is going in.
|
I was was gonna say some kind of flow meter would be the best. So ^^^^^^^^^^ X2.
|
Yea using a flow meter was what I was thinking of too. You would have to run the output signal from the flow rate sensor through some circuitry to convert it to a signal that corresponds to a volume that has passed through the flow meter. Then your gauge would also have to be calibrated to match the signal corresponding to the volume.
|
Just put a vent line on your sac. When you hear water coming out the side of your boat you know its full. Cheap and easy
|
|
All times are GMT -7. The time now is 11:04 PM. |