I ride an 05' hyperlite state, with the state bindings. I love the board and I have never had a problem with it until a few weeks ago. My rear binding had a jiggle to it so i tightened it and it seemed to fix the problem. A few minuets later, i cut out toeside and i can feel my rear binding tweak. It moved a few degrees. So I decided to call it a day. I went home and put in a new "claw" and it doesnt move when i ride anymore but a few days ago, the jiggle came back again. Any suggestions?
|
Without seeing it's them hard to say. <BR>Make sure they are tight, and make sure when you tighten them the teeth are lined up properly. If that doesn't work try a little lock tight.
|
keep a phillips in the boat
|
The screw is tight, but the binding still jiggles
|
then maybe try adding another washer to the claw if it's not tightening the bindings down
|
that would make it looser wouldnt it?
|
I think what Brian is suggesting is that your screw is a bit too long. If that is the case, by adding another washer to the claw, the screw will be able to "dig deeper", thus is will be tighter, not looser.
|
ok, ill try it and get back to you
|
All times are GMT -7. The time now is 11:28 AM. |