I bought a Monster Tower about three years ago and have been very happy with it. However, recently the four main bolts won't stay tight through a run of boarding and I think it is time to replace the bolts and nylock washers. Has anyone had these issues? I have looked all around Knoxville for replacements, but can't find them and I have emailed Monster and called and left a VM, but have not gotten a response. Any help would be appreciated. Thanks,
|
You should get a product called loctite 609. put it into the threads of the bolt and screw on the nut. let it sit for 24 hours and you are good to go
|
John, did you make sure to put in the four expanding bolts as well (two on each top corner of back hoop). I was getting some sway and wiggle from my tower so I called Monster to see about what I could do, apparently the installer never drilled through the pilot holes to set the expanding bolts in there. Monster sent me a set of them since they are such a great company; but I would think that with those, there would be no reason for the bolts to back off.
|
The four expanding bolts have been in since day one of use. We have used the tower for three seasons now without any problems. Now, even during a set it can become so loose as to sway 2-3 inches on a jump and the bolts are loose.
|
Just wanted to update the post - Monster Tower is shipping the bolts today. As always, great customer service. Hopefully this will cure the problem.
|
Monster tower is freaking amazing with their customer service. they will bend over backwards for their customers
|
All times are GMT -7. The time now is 4:19 AM. |