Where does this mount? 2003 Supra SSV
 

I feel dumb for asking, but my throttle was acting up last weekend and I discovered the throttle housing/perfect pass control came loose from the mounting position. We had to manually adjust the knob to get the throttle cable back in line with the actual movement of the throttle by the driver. Does anyone have a picture of where this should be mounted? Boat is a 2003 Supra SSV with Indmar with Perfect Pass (I think it was called Wakeboard Pro). Any help is greatly appreciated.

Jamie, believe it or not as I recall when the dealer installed my WBP/PP on my '06 Moomba OBV, the servo/body was zipped tied to a radiator hose at the rear of the block. Looked kind of hinky but I never had a problem with it in 4 years. Look for some dead zip ties on the block or in the bilge and some attachment marks on the hoses, bet you figure it out.

Jamie after looking closer, it may have been attached using hose clamps. The *** on the curved piece just to the left of your thumb in the first picture would of been where the clamp went over. Most likely a corresponding *** a the 6 oclock position in that photo as well. Can't spell t1t on this site I guess

Here's a pic of attachment on my 2003 ssv - it attaches via hose clamps on the port side of the hose exiting the thermostat housing.

Ryan - thank you very much for posting the picture.