Ok, so i love my RLXI. Biggest shortfall was passenger side cup holders though. <BR> <BR>Bow cup holders are good, rear seat cupholders( well, cup warmers since no box insulation) work fine, drivers side has one good one. <BR> <BR>Decided to fix the problem. Also added a 2nd drivers cupholder, cause one is always filled with ipod/phone, etc. <BR> <BR>What do you guys think? <BR> <BR>[IMG]<a href="http://lh3.ggpht.com/_iYydDhn-t6k/SqldREchLpI/AAAAAAAAANY/0u48BCBNJvY/s640/IMG_2296.JPG" target="_blank">http://lh3.ggpht.com/_iYydDhn-t6k/SqldREchLpI/AAAAAAAAANY/0u48BCBNJvY/s640/IMG_2296.JPG</a>[/IMG] <BR> <BR>[IMG]<a href="http://lh3.ggpht.com/_iYydDhn-t6k/SqldREchLpI/AAAAAAAAANY/0u48BCBNJvY/s640/IMG_2298.JPG" target="_blank">http://lh3.ggpht.com/_iYydDhn-t6k/SqldREchLpI/AAAAAAAAANY/0u48BCBNJvY/s640/IMG_2298.JPG</a>[/IMG]
|
Looks pretty good. The only thing I would say against it is it looks like a shin breaker.
|
Its just slipped over the pylon, so i can really adjust its height. I haven't been out on the lake yet, just put it together this morning. Space IS tight in that area, but thought it would be worth it. <BR> <BR>Also, its removable if its in the way.
|
how did you fabricate that?
|
THanks for the compliments. <BR> <BR>Yes, its just a slip fit with a neoprene koozie protecting the pylon. <BR> <BR>Not really into it to make them to sell, but $$$ talks, haha. <BR> <BR>I used a 6" square plastic garden drain grate thing wiht a 3" pipe deal on teh bottom. <BR><a href="http://www.idealtruevalue.com/servlet/the-39919/Detail" target="_blank">http://www.idealtruevalue.com/servlet/the-39919/Detail</a> <BR> <BR>Then just got some stainless poker table cupholders off of ebay. <BR> <BR>A little bit of 1/4" plastic, some time, and a 3" hole saw, and it was done!
|
|
All times are GMT -7. The time now is 11:38 PM. |