How to remove hard tank on san 210?
Ok
I have a 2001 super air and I am trying to remove my rear vdrive hard tanks. I got out the driver side one okay but the other one is too big to remove, can anyone tell me how to get it out? |
I went through this too. No one really helped me out other than telling me to take a sawzall to it.
Take the brackets all the way off and lift the front end up about 6-10 inches and drag the whole tank towards the bow. You might have to lift up on the back of the tank to clear the dump pump. Go all the way to the back of the seat. Then, lift up on the back of the tank and it will come right out. It took me about 2 hours to figure out how they come out but they came out the same for both of mone. I also have the team wedge tanks too. |
I have the flat tanks not the wedge is that what u are talking about
|
I just had a buddie take his tanks out of his 02 210, I will pass on this thread...
|
I pulled mine out of an '02 a couple weeks ago. I had to remove the supports for the center (engine) section of the sunpad. The '01 may be a tighter squeeze as the deck is wider and the rear of the boat slopes a little forward compared to '02-'06 boats.
|
Yea I removed the supports and there is still no way it is coming out...
|
IIRC we removed ours by pushing it into the cabin when the rear seat back and base was removed.
|
All times are GMT -7. The time now is 4:57 AM. |