I've heard a few people mention sanding down molded fins on some boards and I was just wondering what all this takes and the dangers of doing it. I mean just sand them down to the depth you are looking for and roll with it or do you have to do anything to touch them up after? Maybe a silly question but input would be appreciated.
|
run the board through a wood planer til you get the desired effect
|
ryan, im really hoping your joking
|
i wouldnt suggest grinding anything down on your board... unless you have a lot of money to throw around on new wakeboards every other week. water will get inside and do damage to the core. i suggest you just dont do it..
|
I think the byerly was the only board you could safely do that with
|
That's the one I was asking about Ben.
|
All times are GMT -7. The time now is 2:57 PM. |