WakeWorld

WakeWorld (http://www.wakeworld.com/forum/index.php)
-   Boats, Accessories & Tow Vehicles (http://www.wakeworld.com/forum/forumdisplay.php?f=3183)
-   -   PP servo motor help quick!! (http://www.wakeworld.com/forum/showthread.php?t=782902)

ryanw209 08-20-2010 10:53 AM

PP servo motor help quick!!
 
Hey guys/girls.m The other day I was out and my perfect pass started dropping the boat to neutral as soon as it would kick on. The servo motor test seems to be working on but the phase test shows 0 continuity on the black wire. I tested the wires at the master unit under the dash and it seems to have power there. I'm leaving for a camping trip this evening and would like to get the PP working before I go. Has anyone had this problem before? Do I need to get a new servo motor or could it just be the wire? Thanks!!

ryanw209 08-20-2010 3:57 PM

bump

t0nyv831 08-20-2010 4:09 PM

I would reseat all my cables at the master unit and servo motor to remove any oxidation from the contacts. BTW, do you have gps or paddle? Reason I ask is because mine was doing the same thing (Speed would drop off) and come to find out it ended up being the location of my gps puck. It was being covered every now and then from people riding in the bow. GL.

Tony

AndersonMC 08-21-2010 12:54 PM

I had the same problem and had to finally take it to the shop. Servo motor ended up being bad and they had to replace it.

4white 08-24-2010 9:38 AM

Hey Ryan

I too have a 06 V215 and my PP servo motor went on me, just call the guys at PP and they can ship you a new servo in a couple of days. It is really easy to swap out, it will probably take you 20 min.

ryanw209 08-25-2010 1:06 PM

Thanks for the replies guys.

Antonio - I have a paddle wheel type

Richard- I have a feeling the servo is going out but I did use it this weekend and it worked on and off so that makes me think it may be a bad connection somewhere...

trace 08-25-2010 2:27 PM

You can take the servo motor apart yourself and clean the rust out. I had to do this to mine about 3 yrs ago, and it's still working great. It is very simple to disassemble.

olmoomba 08-26-2010 8:54 AM

Also check your connection at the gold resistor. I had a problem with that breaking yet still intermittent contact because of the shrink tube.

ryanw209 08-27-2010 11:04 AM

Fred I'll check it out.

Trace- I went out to work on it again yesterday and now the servo is completely seized up. Looks like I'll probably be spending the $165 on a new one....

trace 08-30-2010 2:18 PM

Mine was completely seized up when I took it apart.

wake_upppp 08-31-2010 5:17 PM

Dont spend the money! Mine was seized as well and it came apart and cleaned up in a jiffy. Back working like new. Check my thread about it for more details...


All times are GMT -7. The time now is 9:30 AM.