Just got a new pair of 09 Ronix One bindings. Has anyone molded a pair or know how to without the use of a machine.
|
I've heard it can be done with a hairdryer BUT with $400 invested, isn't it smarter to take them in and do it right? <BR> <BR>-Steve
|
I molded a pair I had. Just get a hair dryer and place on low. Heat binding for 5-10 minutes then immediately place on and stand for ~5 minutes. Hope this helps.
|
I was told hot tub could do it
|
Yea I will try the hair dryer on low and just closely monitor them closely. Thanks.
|
idn about ronix but i molded my vantages in a hot bathtub! idn if it molded em persay, but it definatly helped break em in.
|
just wear them and they will mold naturally over time.
|
binding machine operates at 119 degrees
|
I took my to a local sports shop that has the same machine for doing ski/snowboard boots or hockey skates.
|
yea, I took my 08 Ones and ran them in the tub with the water temp all the way up, let em cool a bit (so they dont burn your feet) and popped my feet in there. They molded extremely well.
|
The tub is exactly what I did. Worked extremely well
|
Or just ride them and break em in that way? It took me about 4-6 sets to get the same effect as heat molding.
|
are you taking the sock out or just putting the whole boot in the tub
|
you gotta put the entire thing in so when you put your foot in you can cinch them up to mold to your foot.
|
it's just marketing. don't worry about it. you think danny harf heat molds his bindings? you won't be thinking about whether or not your bindings have been properly heat molded when you're edging into the wake.
|
All times are GMT -7. The time now is 5:39 AM. |