How do you tighten a talor windsheid? I just notice that the left side is loose. please help

usually you pull out the plastic insert that runs in the glass frame and access the screws from there...

i dont think there is plastic on the windsheild.There is a rubber that goes around the glass.

Just below the glass on the aluminum frame is a rubber gasket that runs the entire length of the windshield. Start in a corner and remove the rubber, behind it will be some Phillips head screws at an angle into the deck of the boat tighten these screws and reinstall the rubber gasket.

You may also want to remove the screws completely, one at a time and reinstall them with silicon on them. This will help to keep them tight, especially if you have a system that puts out some bass.

Is the fame loose from the hull? If so move the screws over 1/2 inch. Drill frame and hull and start with new fiberglass..

thanks every body i will remove the rubber and move the screws over 1/2 inch