When I turn on the engine of my 06 X2 none of the gauges turn on. I havnt used the boat in a month since I was on a trip. They dont seem to be getting any power to them but everything else electrical works fine. I tried the braker and its not that. I was thinking maybe a fuse, anyone know where its located or what else it could be.

the fuse box is located in front of the steering wheel. to access it lift up the flip up back to the seat. you will see a carpeted piece that will fold and then remove. the fuses an wire harness are there

Its not a fuse from what I am being told. This problem is happening with several 06 X2's including my own. It appears that some wiring inside that harness is loose and cutting in and out. I assume just from my own experience with this that your PP(if you have it) still works correct? My guages went out the day I took it home and on occasion decide to cut in and out. Have your dealer look at it and inform Mastercraft. Maybe they will look into it a bit deeper and get everyone a permanent fix to this little glitch. Other than that, No problems and love the boat.

Mine does the same thing, if I turn it off and on again it rights it self . The sad thing is there is not a person or dealer within 2000 miles that would have a clue or a tech who is capable of fixing it. Mine has done it from day one .

I have been having problems with my perfect pass, but my guages are working fine and always have. My perfect pass randomly decides not to engage and even though I have tried to adjust settings, it is not smooth at all controlling speed. One day I came out and the clock was reset, the stereo remotes weren't working and the PP started doing that. I wonder if it was a system wide electrical problem....

I have the mastercraft cruise control and thats not working either.

My M/C CC works perfect it just took some time to figure it out after having PP in the last boat .

When my 06 X2 was delivered, a breaker would trip when I flipped the Crts Lights switch to the down position and another break would trip if I flipped the Anc/Nav Lights switch to the Up position. The dealer since fixed it, but I don't know what they did. <BR> <BR>Not to side track the thread, but anyone else with an 06 X2 notice that the front portion of the driver's side Kick Panel is loose? I can reach my hand between the fiberglass and the panel and wiggle it around. Is it mine or are they all like this?