Hey I have some 06 Torqs and I am looking at getting an 06 Watson, the torqs would mount on the board right? I wouldnt need any extra hardware? I know you need hardware for mixing hyperlite ad lf stuff but I wasnt sure about CWB. Thanks guys!

I have Zuess's on a PS3 and have put them on a Watson. you should be fine.

have Factions on a LF Fish, not a problem.

Got some Zeus's on a Fish and good to go.

My Zeus's are on my 142 Watson......very light setup,and super comfy.

The key to using CWB bindings on a LF board is that you need the shorter screws since LF does not drill their binding holes as deep as CWB or Hyperlite. When you purchase the Watson just make sure that the store can supply the shorter screws that will allow your CWB bindings to work with the LF boards. I have the CWB Boss bindings on my 06 Watson and I am upgrading to the 07 Zues LE once they are available this spring.

What screws are they?

I didnt need any different screws. Hmmm...

i used to have byerlys on a transcend and all i did was put a couple washers in there and that worked out fine.