I was bored this winter and put stomp pads on my new fish. Turns out I put the back one too far back and want to take it off and move it up a bit. I was thinking of using a hair dryer to heat it up then reapplying with some sort of glue. <BR> <BR>The board is epoxy.
|
Hey Ryan -- I think Jeff has done this more than anyone. I'm sure he'll chime in. <BR> The hairdryer should work, but be careful not to stretch the traction too much. <BR> <BR>Jeff can tell you more about the spray adhesive as well...
|
Yep...that's the process. Get a corner started, especially if one is already starting to unglue. Work slowly and keep a constant "pull" as you go. It should come up pretty quickly. <BR> <BR>3M spray adhesive - super 77 I think, I have a can at home. <BR> <BR>Clean your board of any residual and then slap the re-glued pad back down. I've found that I have to weight the stomp pad down while it sets up for best adhesion. <BR> <BR><img src="http://www.wakeworld.com/MB/Discus/messages/559019/580466.jpg" alt="Upload">
|
Sweet, thanks.
|
Go to home depot and get some goof-off. It will make your life easy. Once you have taken it off, clean the board with alcohol. The super 77 may work. You may have to use something stronger...
|
good call on the "goof off" Ian. <BR> <BR>As for the super 77 -- in my opinion the best way to do it is <BR> <BR>1. lay down the traction on the board loosely where you want it to go <BR>2. tape off the area along the edge of the traction with some masking tape (on the board -- not the traction) <BR>3. spray the super 77 on the board trying to avoid overspray (hence the tape) <BR>4. spray the underside of the traction <BR>5. let both start to dry a bit (wait a minute or two) <BR>6. press traction down paying particular attention to the edges <BR>7. remove tape <BR>8. surf!
|
Doesn't "goof-off" contain titanium dioxide? That's a suspected carcinogen. I'd stick with heat and elbow grease. In the event you do go with a solvent - I always like to do a test patch - the board in my picture has the logo painted on the outside...that would go the way of the buffalo <IMG SRC="http://www.wakeworld.com/MB/Discus/clipart/happy.gif" ALT=":-)" BORDER=0> <BR> <BR><img src="http://www.wakeworld.com/MB/Discus/messages/559019/580913.jpg" alt="Upload">
|
All times are GMT -7. The time now is 1:24 AM. |