Drilling 3 more holes in my boat tomarrow for my upgraded ballast on my 05 mobius lsv. I just have the standard black thru hull fittings. Anyone tell me what size hole saw i need to buy
|
Best advise is to measure the OD of what you plan to stick through the hole!
|
when you mark your location below the rubrail, make sure to account for the flange on the thru-hull fitting. IOW, you could drill a hole the right size for the part that goes thru, but not far enough below the rubrail for the bigger diameter of the outside part.
|
I bought a 1 1/16" hole saw for the thru hulls that I have. Don't forget to cut a test hole in a scrap piece of wood first.
|
for the standard bilge thru-hulls they should be 3/4" that's what I used
|
All times are GMT -7. The time now is 12:56 PM. |