LED lighting in a Mastercraft X45
 

This is a follow up to a thread from earlier this year: Got Box....

Lots of LEDs and plexiglass rings. Here are some pictures.

Bow cup holders
Attachment 1217
Tower with 485 and Pro80s
Attachment 1218
Rear accent lighting changed to yellow and added 2 more pairs of of JL components.
Attachment 1219
Couldn't forget the drivers cup holder
Attachment 1220
Wet Sounds Pro 80 with 3/4" Plexi ring
Attachment 1221
Sub Enclosure with 2 Boston Acoustics SPG 555s.
Attachment 1222
What a view!
Attachment 1223

This boat is not just for shows. It is used and enjoyed more than any other boat I have worked on. Keep an eye out for this boat on the American and Sacramento River or anywhere else in Nor Cal. Look for it at Spring Ride.

Personally, I think that is one of the best LED setups I have seen. Looks very classy.

Wow, That looks great. Very classy. Nice work!

Looks unreal, nice job!!

The boat sounds even better than it looks!

The stills are great but I like the video of the malibu better.....

That's Crazy! I bet it looks great on the water at night

Darick - The LED lighting looks great even in day light.
Attachment 1515

did you build all the LED rings? Mind showing some pics of how you did it?

I just built a router table for my shop and have been experimenting with a few idea's of how to do this.

Wow... Very nice..

John- I don't have very many pictures of the build process but I will send you the ones I have when I get to my home computer. I'm doing them with a router table for now.
Richard- Thanks. The yellow ended up looking really nice.

Ben, that looks awesome. They look so nice during the daytime as well.

I considered putting a sub in front of the driver's feet, but there is all of the electronic gadgetry behind that wall. Was it hard to relocate all of that? How was it done?

And if you have a pic of the back of the box to illustrate that would be great.

Thanks for the reply Ben. I'm going to post a question about the RGB's in a new thread looking for advice. I'd love to see the pics of the rings and what type of LED's you used. Thanks....

Ben, on the led rings are the edges smooth, or did you use some sort of an etching compound to make them rough?

Talltige - There was a 3cu.ft. box behind that location already so some of the electronics were already moved. The only thing that had to move was the fuse box and that was only a few inches. The only build pics I have are in the "Got Box" thread that I linked above.

John - PM me to remind me to send you some pics

Matt - Sandpaper to fog the rings.