Xstar 2005 Perfect Pass Log Out | Topics | Search | Register | Edit Profile | User List
Last Day | Last Week | Tree View | Moderators | Help/Instructions
WakeWorld Discussion Board » >> Boats, Accessories & Tow Vehicles Archive » Archive through March 18, 2009 » Xstar 2005 Perfect Pass « Previous Next »
By Chris Hilbert (chrizzel) on Tuesday, June 10, 2008 - 11:23 pm:    Edit Post Delete Post
Hey everybody,
since last weekend we have a very weird problem with our Perfect Pass:
When it is not engaged and you accelerate with the throttle, Perfect Pass shuts down, reboots, and then takes the whole power off the engine and goes into idle.
If PP is engaged the boat will not go over 6mph and RPM mode does not work either.

Any ideas?

(Xstar 2005 with the 385hp 6.2 engine)

 
By Aaron Adams (perfectpass_pro) on Thursday, June 12, 2008 - 8:37 am:    Edit Post Delete Post
Is this a drive by wire boat, or mechanical linkage boat?

Aaron

 
By dhcomp (dhcomp) on Thursday, June 12, 2008 - 8:40 am:    Edit Post Delete Post
What is your electrical situation? Seems to me the restarting is the voltage to the PP dropping below 10.5 volts
 
By Mike (ponyh8r) on Thursday, June 12, 2008 - 9:04 am:    Edit Post Delete Post
I would guess that it is either low voltage or the ground wire is not getting good contact. Both would cause it to turn on and off over and over.
 
By Chris Hilbert (chrizzel) on Thursday, June 12, 2008 - 2:59 pm:    Edit Post Delete Post
Hey,
it's drive by wire, and all the tests on the PP ran without any trouble.
The strange thing is that the problem occurred from one day to the next... and that the pp just turns of when accelerating, and when it is engaged it doesnt go above 1600rpm or 10km/h

 
By Aaron Adams (perfectpass_pro) on Tuesday, June 17, 2008 - 6:13 am:    Edit Post Delete Post
hey Chris,

You should check your voltages as the other guys have mentioned, but the other thing to look at is the 9-pin connector that ties the PerfectPass harness to the MasterCraft wiring. On the 2005 version there was a throttle feedback wire attached to PerfectPass that could cause the boat to go into "limb mode" if the teleflex handle pots become misaligned over time. You should only have 7 wires in this 9-pin plug. Location 8 should not be connected to anything on the MasterCraft side of the plug (this wire is YELLOW).

Aaron

 
By Chris Hilbert (chrizzel) on Tuesday, June 17, 2008 - 3:27 pm:    Edit Post Delete Post
Heyhey,
we found the problem. It was indeed a bad connection in the 14 pin connector. Green Cable => VGOV.

Thx a lot for your help however, and whenever you're in Luxembourg come by for a ride : www.youthwake.lu :-)

 

Topics | Last Day | Last Week | Tree View | Search | User List | Help/Instructions Administration
Privacy Policy | Terms of Use
WakeSpace is owned by eWake, Inc.
Copyright © 1996 - 2009, All Rights Reserved.
WakeSpace@WakeWorld.com