Tower clamp inserts Log Out | Topics | Search | Register | Edit Profile | User List
Last Day | Last Week | Tree View | Moderators | Help/Instructions
WakeWorld Discussion Board » >> Boats, Accessories & Tow Vehicles Archive » Archive through April 21, 2006 » Tower clamp inserts « Previous Next »
By P M H (caffeineguy) on Monday, March 20, 2006 - 6:57 am:    Edit Post Delete Post
Where can I buy just the inserts for tower speaker clamps? I need to go from 1 7/8" to 1 5/8". Help a brotha out.
 
By gordon (gmarkham1) on Monday, March 20, 2006 - 7:01 am:    Edit Post Delete Post
monstertower.com


 
By adam Curtis (acurtis_ttu) on Monday, March 20, 2006 - 7:15 am:    Edit Post Delete Post
As far as I know monster tower only sells inserts to fit their tower clamps. I looked around for a while w/o any luck. You'll either need to have them made somwhere or figure something else out...your only talking about a 1/4 inch. I used some black weatherstripping they use on the bottom of garage doors.
 
By michale detillion (michale) on Monday, March 20, 2006 - 7:44 am:    Edit Post Delete Post
if they are the smooth on the inside clamps then i dont think weather stripping will work.sounds like you will have about an 1/8" all the way around. Try to find a small sheet of 3/16" rubber. Thats what i used on my Raul clamps when i moved everything over to my mew smaller tower.
 
By adam Curtis (acurtis_ttu) on Monday, March 20, 2006 - 7:50 am:    Edit Post Delete Post
The weather stripping I used (garage door) is a rubber material. My clamps are smooth inside, I haven't had any type of movement on mine. Ideally if you could find some of those old twist off grippers ( like when a jar is hard to open) Those would work great.
 
By Aaron Nielsen (lzyboy) on Monday, March 20, 2006 - 8:07 am:    Edit Post Delete Post
- Rubber inserts
- Velcro / fuzzy side
- Pipe insulation / rubber / foam
- Camper truck & bed Weatherstripping

Lzy

 
By P M H (caffeineguy) on Monday, March 20, 2006 - 10:45 am:    Edit Post Delete Post
I'm not sure if weatherstripping or rubber would work.
I've tried duct tape(really) wrapped a couple times, but the top of the tower is somewhat curved on the top and it did actually slide down. I think hard plastic would work the best if I could find the exact diameter that I need.

 
Topics | Last Day | Last Week | Tree View | Search | User List | Help/Instructions Administration
Privacy Policy | Terms of Use
WakeSpace is owned by eWake, Inc.
Copyright © 1996 - 2008, All Rights Reserved.
WakeSpace@WakeWorld.com